Make a city scene - crafts for kids

I've been going through A LOT of cardboard tubes recently, and the city tubescapes we did a few weeks back got me thinking about making a bigger city scene that could be added to and played with. The first thing was to make the tubes less, well, tubey.....!

You'll need:
Cardboard tubes (toilet paper and kitchen paper tubes)
Scissors
Paint
Black felt tip or gel pen
For the trees:
Cereal box card
Brown felt tip
Glue stick
Grey paper (or painted paper) for the street

1. Take your toilet paper tube or kitchen paper tube and flatten it on the table with you hand. Press firmly along the two creases.

2. Squeeze the tube open, line up the two creases you've just made, and flatten with your hand - making two more creases. Press firmly along them both again.

3. If you want to make your buildings different heights, this is a good time to cut across your flattened tube. Now, when you squeeze it back into shape, instead of being round, you should have more of a square shape.

4. Paint your buildings any colours you like, or leave some plain, like we did.

If you want to make trees, this would be a good time to paint some cereal box card green. Try two different colours of green. Add more blue to make a darker shade.

5. When the paint's dry, press along the creases again, to get them back into shape, then use the black pen to add windows. Draw small rectangles, colour some in and leave others open. Add any extra details you want - Daisy made a hospital, shop and a bakery. It's absolutely up to you!

6. For the tree base, cut a strip of plain cereal box card. The trees can be any size you want, but if you want them to be a similar size to ours, keep the width of the strip to about 2cm/3/4in or less.  Cut the strip into similar sized pieces, no more than about 3cm/1in. long (these measurements are just a guide, the card pieces don't need to be identical or precise).

7. Now, fold in both ends of a piece of card, so you leave a small section in the middle between the folds. This is going to be the trunk of your tree and shouldn't be too wide. It might take a minute or two to get the hang of the folding, but again it doesn't need to be precise, as long as the card piece sits steady.

8. Make a small snip down both creases (snip a little extra out to make it easier to slot in the treetop later) - then cut a 'V' between the slots for the tree's branches.

9. Keeping in mind the size of your tree base, draw a treetop shape on the painted green card and cut it out. Keep the shape simple if you prefer.

10. Draw the trunk on the tree base with a brown felt tip pen.

11. Rub some glue on the back of the branches only, and slot the treetop in place. Leave it flat to dry (you could weigh it down with a book).
Fold the flaps back and your tree is ready!