19.4.17

Curly wurly snakes!


Wrap them wherever you like!


These spirally snakes are sssssssimple to make and they're really good for scissor practice too.

You'll need:
2 toilet paper tubes (or a kitchen paper tube cut in half)
Paint
Paper
Craft glue
Glue stick
Plain paper
Yellow felt-tip or highlighter

1.  Paint stripes up one tube using any colours you like. It looks good if you keep to a set pattern, so if you paint yellow, green then blue do the same around the rest of the tube. Try to keep the stripes a similar size.
On the second tube, paint the same colour pattern around the tube, leaving a space near one end. Make the stripes a little thinner this time. Paint the bit you've left black, or whatever colour you'd like for your snakes tongue! Paint the inside of this end black too.



2. When the paint's dry, carefully cut the tube to make a spiral. Take your time and make small snips with the tips of the scissors. Don't make the angle too steep at the beginning - just a gentle rise. When you've been round once, the important thing is to keep the width of the spiral (your snake's body) the same all the way up. Keep checking to see if it looks right. This can be tricky and needs concentration but it's great scissor practice. If it helps, you could try drawing a spiral on first with a pencil, or, for younger makers, start it off for them, as this is really the trickiest part. Let them have a go at cutting the rest of the spiral. It doesn't matter if it's a bit wiggly!



3. Snip the end off so you have a nice straight bit to stick the head to.


4. Use a pencil to draw a diamond shaped head on your other tube ( make sure it's not too small)


5. Use sticky tape to attach it to the twisty body.



6. Cut out an eye shape from the spare tube. We tried two different shapes. Draw around it twice on some plain paper and colour in with a yellow felt-tip pen or a highlighter. Add a black pen line down the middle. Cut them out and use a glue stick to glue them to the head.




7. Cut a thin strip from the black end of the tube for your snake's tongue. Straighten off both ends and cut a 'V' in one of them.



8. Use sticky tape or glue to stick the tongue to the back of the head. Add two black nostrils and any other detail you like. Now your snake is ready to explore!